90 degree Corner Centre T for 27mm Galvanised Pipe img2 and vertical galvanised pipe of

and vertical galvanised pipe of an outside diameter of approximately 48mm

Plantation grown finger jointed Radiata Pine that has been H3 treated (suitable for above ground use)

Where would you normally use a treated timber eave bracket

The 101 Short Tee is a 90 degree butt joint

The 117 fittings are a retro-fit type fitting designed to be added on to existing structures without the need to dissassemble The 117Y fitting comes complete with 4 socket pieces and 3 plate pieces which enable each kit to be used to make one of the three possible assemblies illustrated below

90 degree Corner Centre T for 27mm Galvanised Pipe img2 and vertical galvanised pipe ofWhere would you normally use this galvanised pipe fitting? The 116 is a 90 degree corner joint, often used on middle rail on level sites and often paired with type 128. This fitting cannot be used where through tube (vertical in photo) has to be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 27mm. What is it made out of? All of the pipe fittings are